Securalift Garage Door Opener Troubleshooting

Look through the table below. The information in it can be useful for you if you are the owner of Securalift Garage Door Opener. In case of failure and the need to fix the problem, you can determine the causes of the failure and use the tips from the manual for troubleshooting. Look at the table and make sure that you do not always need to call the repairman.

Symptom	Possible cause	Remedy
Door will not operate	Mains power not switched on	Switch on mains power
	Door is obstructed	Remove obstruction
	Door is locked or motor jammed	Unlock door or remove jam
	Door tracks/hardware damaged	Door requires service/repair by qualified technician
Door starts to close but automatically reverses to open position	Adverse weather conditions (wind or cold) causing door to stiffen and become tight in the tracks	Increase force margin setting.
	Possible obstruction in the doorway	Remove obstruction
Door operates from drive unit (operate) button but not from transmitter	Transmitter code not stored in memory	Code transmitter into opener's memory.
	Flat battery	Replace battery
Door will not close fully	Door limits position need to be reset	Reset limits positions.
Door will not open fully	Door limits position need to be reset	Reset limits positions.
Courtesy light not working	Faulty light	Replace lamp
PE Beam click but door does not reverse open when PE Beam is obstructed during close cycle	Wrong value of resistor is used PE Beam or wiring faulty PE Beam not aligned correctly PE Beam is obstructed	2k2 ohms resistor must be used on the receiver of PE Beam
		Remove obstruction